This course is designed for candidates to develop the advanced skills needed to design and maintain radio communication systems.
“Radio Technician” course gives the candidates the advanced knowledge how to design and maintain radio communication systems. The basic knowledge of DC and AC circuits is given, the symbols and purpose of electrical components are shown, various measuring equipment is explained and demonstrated, antenna system installation is explained, frequency mixing and transmission lines are mentioned, effective radiated power and baluns are explained, repeater operation and shift will be explained, soldering techniques of different joints and connectors will be shown and practised, radio interfaces will be explained and software applications will be explained and some of them demonstrated, radio programming will be explained and practised.
Includes: military snack/lunch and drink and accommodation.
Skill prerequisites and Requirements
The candidate does have to possess prior experience working with radio communication devices as well as basic knowledge with radio communication systems (Radio Communications Intermediate Course).
270€ (VAT Included)
Next free term
4 December 2020 5 December 2020
- Alternating and Directional Current
- Electrical Symbols and Components
- Ohm’s Law and The Power Law
- Kirchhoff’s Circuit Laws
- Basic Measuring Instruments
- Resistor Colour Codes
- Series and Parallel Circuits
- Capacitor and Inductor Behaviour
- Phase Difference(Shift)
- Multimeter Operation
- Frequency Mixing
- Antenna Installation
- Vehicle radio systems
- Transmission Lines
- Effective Radiated Power
- Repeater Shift/Offset
- Repeater Antenna Setup
- RF Measuring Equipment
- SWR Meter (Standing Wave Ratio)
- Dummy load
- RF Directional Wattmeter
- Frequency Counter
- Antenna Analyzer
- Signal/Function/Arbitrary Waveform Generator
- Spectrum Analyzer
- Wire Joint Soldering and Twisting
- Connector Soldering
- Wire Gauge-Types and Colours
- Crimp Terminals and Connectors
- Radio Interface
- Radio Programming
- Software Applications
- Practical Exercises
The course will be taught using theoretical and practical exercises. The lectures will be conducted in the classroom, and the exercises will be held in the classroom and/or outside. The course candidates will be given the LYNX TC equipment during the course.
Clothing appropriate for climate and conditions. Candidates will Use our Portable Radios, Mobile Radios, Multimeter, Antennas, coaxial cable and connectors, Repeater, SWR meter, Frequency counter, SDR (Software Defined Radio), Laptop/computer, Wattmeter with dummy load, Soldering iron, solder, solder pump, Wires, electronic components, circuit boards, Radio interface and software applications, Radio programming cable and software, etc…
Book your training now
|4 December 2020||5 December 2020||AVAILABLE|
PENDING Pending is status that indicates that all free places for this order has been booked but payment has not yet been processed. For most purchases, the seller will complete the payment within a few days of receiving the order.